Process of rear axle regeneration

Below you will find description of rear axle regeneration for Peugeot 106, Peugeot 206, Peugeot 306, Peugeot Partner, Citroen Berlingo, Citroen Xsara, Citroen Xsara Picasso, Renault Megane and Renault Scenic. In order to do such process,  specialized tools is needed as well as  years of experience and knowledge of French vehicles. The whole process is divided into 9 stages.

Process of rear axle regeneration Peugeot, Citroen, Renault

1) Dismantling of swinging arms

Dismantling the swinging arms from the rear axle base is done by specialized hydraulic pullers.

2) Removing the rear axle base (center part)

Special hydraulic table pulls out pins.

3) Sandblasting

We clean all parts from rust with sandblasting.

4) Trailing arm regeneration

We regenerate trailing arm first and then check geometry.

5) Painting

Painting helps prevent corrosion of parts

6) Bearing assembly

The bearings will be mounted with a special press, without hitting.

7) Assembly of the axle base

Hydraulic press fitting prevents deformation of the beams

8) Checking the axle base (central part)

The geometry of the beam base is checked

9) Mounting of torsion bars

In the final phase, torsion bars are mounted.